Environmental Characteristics of 315AS4 SAW Filter
1.Temperature cycling
The 315AS4 SAW filter must be in a place with low temperature, -40 ℃ for thirty minutes, following by a high temperature of 25℃ for five minutes and then a higher temperature of 85℃ for thirty minutes. When the device is released into a room with normal temperature conditions for one or two hours prior to the measurement, it shall meet the specifications in table 1.
2. Resistance to solder heat
Submerge the 315AS4 SAW filter terminals into the solder bath at 260℃ ±5℃ for 10 ± 1 second. Then release the device into a room with normal temperature conditions for four hours, it shall meet the specifications in table 1.
3. Solderability
Submerge the device terminals into the solder bath at 245℃ ±5℃ for five seconds. More than 95% area of the soldering pad must be covered with new solder; the 315AS4 SAW filter shall meet the specifications in table 1.
4. Mechanical shock
Drop the 315AS4 SAW filter randomly onto the concrete floor from a height of 1 m three times. The filter shall fulfil the specifications in table 1.
5. Vibration
Subject the device to vibration for two hours each in x, y and z axes with amplitude of 1.5 mm at 10 to 55 Hz. The filter shall fulfil the specifications in table 1.

Remarks for 315AS4 SAW Filter Usage
1. Static voltage
Please avoid static voltage between signal load and ground, it may cause deterioration or destruction of the SAW filter components.
2. Ultrasonic cleaning
Please avoid ultrasonic cleaning, it may cause deterioration or destruction of the SAW filter components.
3. Soldering
Please avoid soldering different parts of the SAW filter components, just leads may be soldered.

Packing of 315AS4 SAW Filter
1. Dimensions
(1) Carrier Tape: Figure 1
(2) Reel: Figure 2
(3) The 315AS4 SAW filter shall be packed properly to avoid damage during transportation or storage.
2. Reeling Quantity
1000 pieces/reel 7’’
3000 pieces/reel 13’’
3. Taping Structure
(1) The tape shall be wrapped around the reel in the direction shown below.

(2) Label

(3) Leader part and vacant position specifications.

Tape Specifications of 315AS4 SAW Filter
1. Tensile Strength of Carrier Tape: 4.4N/mm width
2. Top Cover Tape Adhesion(See the belowfigure)
(1) Pull off angle: 0~15º
(2) Speed: 300mm/min.
(3) Force: 20~70g